2016 Nissan Versa Oil Filter in Mesa, AZ

Yes—the oil filter on a 2016 Nissan Versa should be replaced at each oil change.

Fresh oil needs clean filtration to keep debris from circulating. As a filter loads, its bypass valve can open to maintain oil pressure, which means unfiltered oil may circulate. Replacing the filter with each oil change keeps filtration consistent and protects the 1.6L inline 4-cylinder’s fine passages. Follow the manufacturer’s maintenance schedule and driving conditions to time your visits.

• New, engine-matched filter installed
• Old gasket removed and sealing surface renewed
• Post-service leak and level check

The old filter is removed, the sealing surface is cleaned, and a new engine-matched filter is installed with a final leak and level check.

Technicians drain the oil, remove the used filter, and ensure the old gasket isn’t stuck to the housing. A new filter matched to the Versa’s 1.6L inline-four is fitted and tightened correctly. After filling with the oil grade the manufacturer specifies, the engine is run and inspected for leaks, then shut down for a final level verification.

• Filter replaced and gasket/seal renewed
• Fresh oil added and circulated
• Leak inspection at filter and drain plug

The filter can load up, trigger the bypass valve, and allow unfiltered oil to circulate through the engine.

When the media clogs, the bypass valve opens to maintain pressure, but debris is no longer captured effectively. Over time, unfiltered oil can accelerate wear in bearings and cam surfaces. Skipping the filter change also risks gasket issues at the next service. Replace the filter whenever the oil is changed to keep your 2016 Nissan Versa protected.

• Bypass valve may open under restriction
• Unfiltered oil quietly increases wear
• Seals may harden or deform between cycles

Yes—the filter is matched to the 1.6-liter inline 4-cylinder engine and filters are not interchangeable across engines.

Filters differ in thread, gasket diameter, bypass calibration, and media design. The 2016 Nissan Versa’s 1.6L I4 requires a filter that fits correctly and meets this engine’s operating needs. Using a mismatched filter can cause leaks, poor filtration, or incorrect bypass behavior. Your service advisor will install a filter designed for this application without needing to reference a part number.

• Correct fit and sealing surface alignment
• Bypass valve suited to engine’s oil system
• Media sized for expected debris load

It can be done, but it is not recommended because the old filter may send unfiltered oil through the bypass valve.

Running fresh oil through a loaded filter limits the benefit of the service. As restriction rises, the bypass valve can open and let unfiltered oil circulate, which quietly increases wear. Best practice is to replace the filter at every oil change so the oil and filtration start fresh together and protect the engine as intended.

• Fresh oil pairs with fresh media
• Reduces chance of bypass operation
• Helps maintain stable oil pressure

Book online using schedule service or schedule appointment, or call our Mesa team for assistance.

Choose a time that fits your day and review service specials before you confirm. Online booking lets you pick transportation options and add notes for the advisor. If you prefer to speak with someone, call {{rooftop.phone}} and we’ll help you set up your visit.

• schedule service for quick online booking
• Check service specials before you confirm
• Call for help with timing or questions