2014 Nissan Versa Note Oil Filter in Mesa, AZ

Yes—the oil filter should be replaced at each oil change on a 2014 Nissan Versa Note.

This ensures debris captured in the old filter isn’t sent back through the engine. When a filter loads up, its bypass valve opens so oil continues to flow, but now it circulates unfiltered oil. Replacing the filter with the oil preserves full filtration and helps protect tight clearances during hot-weather Phoenix driving.

• Prevents bypassed, unfiltered oil from circulating
• Matches the service to real-world heat and stop‑and‑go use
• Keeps new oil clean for the full interval

The service installs a matched new filter, renews sealing surfaces, refills with the correct oil, and verifies there are no leaks after the engine runs.

Technicians remove the used filter, clean the mounting base, and fit a new gasketed filter appropriate for this engine. Sealing surfaces such as the drain plug washer are renewed as required. After refilling with the oil grade the manufacturer specifies, the engine is started, checked for leaks, and the oil level is reverified.

• New filter matched to the engine
• Seals cleaned and renewed for a drip-free result
• Warm-engine leak check and maintenance light reset when applicable

The filter loads with debris, its bypass valve opens, and the engine circulates unfiltered oil.

Oil will still flow, but it will no longer be filtered, allowing fine particles to pass through bearings and journals. Over time, that increases wear and can undermine the benefits of fresh oil. Skipping the filter risks contamination that is easy to avoid during a routine service.

• Bypass mode means oil flow without filtration
• Increases abrasive contact in tight clearances
• Negates much of the benefit of fresh oil

Yes—the filter is matched to this 1.6-liter inline 4-cylinder engine, and filters are not interchangeable across engines.

Filter dimensions, threading, gasket design, and anti-drainback features must suit the engine’s housing. Using a non-matched filter can cause leaks, poor filtration, or fitment issues. During service, we install a filter that meets the engine’s requirements without naming part numbers or proprietary specs.

• Correct fit for 1.6L inline-4 architecture
• Proper gasket sealing and thread engagement
• Intended flow and bypass characteristics

It can be done, but it is not recommended because the loaded filter can send unfiltered oil through the engine via the bypass valve.

Keeping an old filter in place leaves contaminants trapped in the media and risks immediate recirculation of debris with new oil. Manufacturer schedules and an inspection of condition guide service timing, but best practice is to replace the filter at each oil change.

• Avoids unfiltered oil circulation
• Protects bearings and cam surfaces
• Aligns with routine maintenance best practices

Use our online portal to schedule service or schedule appointment, or call the store for assistance.

Choose a time that fits your day, and check current service specials before you arrive. We’re located at 2025 W Riverview Auto Dr, Mesa, AZ 85201. If you prefer to speak with a service advisor, call {{rooftop.phone}}.

• schedule service
• schedule appointment
• service specials