2014 Nissan 370Z Oil Filter in Mesa, AZ

Yes—the oil filter on a 2014 Nissan 370Z is replaced with each oil change under normal service practices.

The filter traps debris the oil carries away; as it loads, a bypass valve can open so oil flows unfiltered. Replacing the filter with the oil keeps debris from recirculating and supports stable oil pressure. Follow the manufacturer’s schedule and your vehicle’s inspection results to time service appropriately in Mesa’s driving conditions.

• Fresh, matched filter installed at each oil change
• Bypass valve risk avoided by not reusing a loaded filter
• Service timing guided by the manufacturer and inspection

The service includes removing the old filter, cleaning the base, fitting a new matched filter, renewing sealing surfaces, refilling oil, and leak‑checking after a warm restart.

We verify the gasket isn’t doubled, install the filter to the proper torque, and refresh the drain plug seal before filling with the oil grade the manufacturer specifies for this engine. After running the V6, we confirm there are no leaks and set applicable reminders. It’s a precise, repeatable process built to protect your engine.

• New filter matched to the 3.7L V6
• Cleaned base and renewed sealing surfaces
• Post‑service leak and level checks

The filter can load with debris, trigger the bypass valve, and allow unfiltered oil to circulate through the engine.

Unfiltered circulation doesn’t stop the engine, but it increases wear quietly over time—especially in heat and stop‑and‑go traffic common around Mesa and the Greater Phoenix area. Changing the filter with the oil helps maintain clean flow, stable pressure, and consistent protection for bearings, cam lobes, and VVT components.

• Increased wear from recirculated debris
• Higher risk under desert heat and short trips
• Simple prevention: replace filter with each oil change

Yes—the filter is matched to this engine, and filters are not interchangeable across engines; your 370Z’s 3.7‑liter, 6‑cylinder V‑engine requires the correct type.

A properly matched filter fits the housing, seals correctly, and provides the intended flow and filtration characteristics. Using an incorrect filter can compromise sealing or bypass function. We install a filter that matches this engine’s specification without naming a part number, ensuring it works with the oil grade the manufacturer specifies.

• Correct fit and seal for the 3.7L V6
• Proper flow and bypass characteristics
• Avoids leaks and unfiltered circulation

It can be done, but it is not recommended because a loaded filter can force the bypass valve to open and circulate unfiltered oil.

Reusing the filter leaves captured debris in place and risks recirculation under load. Changing both together is a small step that helps protect precision surfaces and keeps oil pressure behavior consistent. If service history is uncertain, replacing both is a prudent reset.

• Replace oil and filter together for best protection
• Prevents bypass and unfiltered flow
• Resets maintenance baseline

Book online via our schedule service tool or call for help—both options are quick.

Use our online portal to pick a time, note concerns, and see available transportation options. You can also check current service specials before confirming. When you’re ready, head to our online scheduler and we’ll get your 2014 Nissan 370Z on the calendar.

• Use the online schedule service tool
• Call {{rooftop.phone}} for assistance
• Review offers on our service specials page