2012 Nissan Murano CrossCabriolet Oil Filter in Mesa, AZ

Yes—replace the oil filter at every oil change to keep debris from recirculating.

The filter captures contaminants the oil carries away; once it loads, a bypass valve opens and the engine receives unfiltered oil. Replacing the filter with the oil restores full filtration capacity for your 2012 Nissan Murano CrossCabriolet. Follow the manufacturer’s schedule and your driving conditions when planning service.

• Maintains filtration after the old media is saturated
• Helps stabilize oil pressure on cold starts and hot days
• Aligns with common service practices for engine protection

The old filter is removed, sealing surfaces are renewed, a matched filter is installed, oil is refilled, and a warm-engine leak check is completed.

Technicians clean the gasket landing, fit the new filter to this engine, and replace crush washers or seals as needed. After refilling with the oil grade the manufacturer specifies, the engine is run to operating temperature and inspected for leaks before a final level check.

• Removal and disposal of the used filter
• Gasket/seal service and correct filter installation
• Run, inspect, and verify no leaks at filter and drain

The filter can load up, trigger the bypass valve, and your engine will circulate unfiltered oil.

Unfiltered oil still lubricates, but it carries abrasive particles that quietly accelerate wear. Over time this can affect bearings and cam surfaces, especially under heat and stop-and-go use. Replacing the filter restores debris-holding capacity and helps preserve consistent oil pressure.

• Increased internal wear from abrasive particles
• Potential for pressure fluctuations as media loads
• Shortened effective oil life between services

Yes—the filter is matched to the 3.5-liter, six-cylinder engine and filters are not interchangeable across engines.

Your 2012 Nissan Murano CrossCabriolet uses a 3498 cc V6, and the filter design (dimensions, gasket, and bypass characteristics) must suit that application. Using the correct filter helps maintain proper sealing and oil pressure. Your service advisor will install a filter appropriate for this engine without requiring you to supply a part number.

• Correct fit and gasket seal for this engine family
• Bypass valve and media matched to system needs
• Supports stable pressure at start-up and high heat

It can be done, but it is not recommended because the used filter may force unfiltered oil through the bypass valve.

Leaving an old filter in place reduces debris capacity and undermines the benefit of fresh oil. The best practice is to replace both together so filtration and lubrication are reset at the same time. Service timing should follow the manufacturer’s guidance and your driving conditions.

• Old media may be saturated and restrict flow
• Bypass valve can send unfiltered oil through the engine
• Changing both maintains balanced protection

Book online using the dealership’s portal—just click schedule service or schedule appointment and choose a time.

Use the online scheduler to select your 2012 Nissan Murano CrossCabriolet, pick oil and filter service, and confirm. You can also review current service specials before you book. Prefer to call? The service team in Mesa can help you finalize details.

• Start here: schedule service
• Compare offers on the service specials page
• Get guidance from a service advisor if you have questions